Welcome to EbauFix.
Prepared,grey and white cement-based mortar, composed from Protland Cement with excellent qualities, carbonate stone filler with selected granulometry, synthetic resins and special additives, which im prove the workability, adhesion and increase the hydrophobicity of the dry mortar. FIBERFIX CONEXION 700/701- serves for the adhesion of all types of panels that are generally used for the realization of thermal insulation systems, such as: styrofoam, graphite, mineral fibers panels in brick walls, concrete or cement-based mortar.
FIBERFIX CONEXION 700/701 serves for the adhesion of all types of panels that are generally used for the realization of thermal insulation systems, such as: styrofoam, graphite, mineral fibers panels in brick walls, concrete or cement-based mortar. The supports must be compact, seasoned and steady, without cracks, oils, paints or detachable parts. Check to see if the bricks are securely attached and do not have parts that can detach. If there are such parts, remove them repair surface with mortar. Walls that are coated with grout must be scraped in order to verify if the surface under it was painted with old and badly attached paints, or if there are detachable parts. Surperficial cracks can be caulked with FIBERFIX CONEXION 700/701, while deep structural cracks should be treated in a way to eliminate the cau ses and not repeat them.
Application: in order to achieve a steady installation, before you start to adhere panels, it is necessary to fix metallic profiles as leveling fasteners. For installations in irregular surfaces, such as unplastered brick walls, the adhesive is applied with a trowel, by putting it as a tape at the edges of the panels’ sideways contours, and some drops in its center (or forming an X in the center of the panel) in a certain thickness so as to compensate unevenness. For applications in flat surfaces, it is recommended to spread the adhesive in the entire surface of the panel through e notched trowel (from 8 up to 10 mm). Caution must be paid to the surface covered with adhesive which should be at least 40 % of the total panel surface.
Panels should be installed in horizontal direction, starting from down and continuing up. Caution to the panels’ joints; do not leave empty spaces or unevenness. Then, proceed with the mechanic fixation of wall anchors (for usual panels 50 x 100 cm, it is recommended to pour 8 adhesive drops for meter square.
Application temperature: +5C to +35C
Storage: 12 months, in original packaging and dry place.